![]() A solution based around an Arduino with the Arduino bootloader installed would fulfil this need.Īn Arduino Uno can easily be used to control the three NEMA 17 stepper motors that control the X, Y and Z axes of the CNC 1610 if it is used in conjunction with a CNC Shield, readily available on Amazon, eBay or AliExpress. Although ways can be found around this by using an external AVR in-system programmer, this would not satisfy the requirement to be able to do this quickly and easily. ![]() This was found to be difficult to do with the Woodpecker based circuit board supplied with the CNC 1610 machine as the firmware cannot be flashed through the USB interface. A particular requirement was the ability to quickly upload different versions of the Grbl firmware, up to and including the latest 1.1h version. ![]() This project was conceived as a test environment for Grbl based firmware and desktop computer based software that interacts with CNC machines. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |